Hanging a bike in a Steadyrack will not cause any damage to your frame, forks or wheels. No part of the bike frame touches the rack, only the front tyre, which is cradled in the steel arms.

Yes! This is a common concern for many bike owners with these types of brakes and suspension. When your bike is hung up vertically, the fluid in your forks will run towards the seals and keep them lubricated. This will prolong their use, so it's actually good for your bike and forks to hang it vertically on our bike racks. If you have hydraulic brakes on your bike the fluid will run down when the bike is hung, so we advise pumping the brakes a few times when you take the bike off the rack if it's been there for a while. The shocks shouldn't leak when the bike is hung up, however if they do it's a good indication that the seals may need replacing. Read our blog post for more information about storing bikes with hydraulic brakes in Steadyracks.

Yes - all our racks are compatible with most types of locks, including chain, cable and D-locks. We have introduced a lock bracket and D lock and cable which is available for purchase on our website. It is also important that you do not rely on the rack arms, as the bolts holding these to the rack frame can be undone.

Steadyrack are assembled using a specific tension for the nuts that hold the central spine to the top and bottom mounting brackets. (torque setting = 5nM) This setting is designed to give sufficient tension to the pivot to ensure bikes can be loaded on any angle without the rack moving around too much. When you remove the 2 plastic caps from the top and bottom the nuts are exposed. You can loosen both nuts and it will free up the rack more and equally you can tighten them to lock the rack into position. We recommend you maintain them so the racks are stiff but can still be pivoted.

The rack can be quite stiff when you use it for the first few times then it loosens up a bit. This is due to the type of fiber washers we use to assist with the stiffening effect.

No, it's not possible to lock the rack solid in one position. You can tighten the nuts sufficiently that the rack will be very hard to pivot which will effectively hold it in the one position. To do this you need to remove the 2 plastic mounting bracket covers (end caps) and tightening the 2 nuts that attach the central pivot bar to the mounting brackets. We recommend you check your fixings to your wall carefully and make sure they are very secure if you do this as any pressure sideways will put extreme pressure on the mounting brackets fixings.